This method initiates a controlled shutdown of applications and the OS before the server enters standby mode.
• Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS. If an
application stops responding, you can use this method to force a shutdown.
• Use a virtual power button selection through iLO.
This method initiates a controlled remote shutdown of applications and the OS before the server enters standby
mode.
3. Verify that the server is in standby mode by observing that the system power LED is amber.
Accessing the product rear panel
Procedure
1. Release the cable management arm.
2.
Open the cable management arm.
The cable management arm can be right-mounted or left-mounted.
28 Operations
To Next Page
Loading...
