HPE ProLiant DL325 Gen10 - Removing the Air Baffle; Installing the Air Baffle

Removing the air bale
CAUTION: For proper cooling, do not operate the server without the access panel, bales, expansion slot covers, or
blanks installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
Procedure
1. If installed,
remove the bezel.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
•
Extend the server from the rack.
• Remove the server from the rack.
5.
Remove the access panel.
6.
Remove the air
bale.
Installing the air bale
Procedure
1. Observe the following alert.
Operations 33