7. Allow all internal system components to cool before continuing.
8. CAUTION:CAUTION:
Heatsink screws must be tightened and loosened in alternating sequence. Do not overtighten the screws as this might
damage the system board or the processor socket.
Use a T-30 Torx screwdriver to loosen one pair of diagonally opposite heatsink screws (callouts 1 and 2), and then loosen the other pair
of heatsink screws (callouts 3 and 4).
9. Set the anti-tilt wires to the unlocked position.
10. CAUTION:CAUTION:
To prevent mechanical damage or depositing oil on your hands or other contaminant to the heatsink contact surface,
hold the heatsink only by the edge of its base plate. Do not touch the heatsink fins.
Lift the processor-heatsink module straight up from the system board.
To Next Page
Loading...
