HPE ProLiant DL360 Gen11

To install an adapter in slot 2 of the primary riser:
a. Remove the primary PCI riser cage
b. Remove the blank.
c. Install the adapter.
8. Install the riser cage.
9. Install the access panel .
10. Install the server in the rack.
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server .
ResultsResults
The installation is complete.
Optical drives and media baysOptical drives and media bays
SubtopicsSubtopics
Installing the 8 SFF display port/USB optionInstalling the 8 SFF display port/USB option
Installing an 8SFF optical driveInstalling an 8SFF optical drive
Installing the 4LFF display port/USB optionInstalling the 4LFF display port/USB option
Installing the 4LFF optical driveInstalling the 4LFF optical drive
Installing the 8 SFF display port/USB optionInstalling the 8 SFF display port/USB option
PrerequisitesPrerequisites
Before installing this option, be sure that you have the following:
The components included with the hardware option kit
T-10 Torx screwdriver
ProcedureProcedure
HPE ProLiant DL360 Gen11 Server User Guide 60