ItemItem DescriptionDescription StatusStatus
1 UID button/LED Solid blue = Activated.
Flashing blue:
1 Hz = Remote management or firmware
upgrade in progress.
4 Hz = iLO manual reboot sequence initiated.
8 Hz = iLO manual reboot sequence in progress.
Off = Deactivated.
2 NIC status LED Solid green = Link to network.
Flashing green = Network active.
Off = No network activity.
3 Health LED Solid green = Normal.
Flashing green = iLO is rebooting.
Flashing amber = System degraded.
Flashing red = System critical.
4 Power On/Standby button
and system power LED
Solid green = System on.
Flashing green = Performing power on sequence.
Solid amber = System in standby.
Off = No power present.
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
To identify components in a degraded or critical state, see the Systems Insight Display LEDs, check iLO/BIOS logs, and reference the
server troubleshooting guide.
Facility power is not present, power cord is not attached, no power supplies are installed, power supply failure has occurred, or the
power button cable is disconnected.
1
1
1
2
1
3
1
2
3
To Next Page
Loading...
