hpmont HD5L series User Manual

Chapter 6 Function Introduction Shenzhen Hpmont Technology Co., Ltd
―68― HD5L Series Controller User Manual
Code Name Description Range
【
factory setting
】
F06.13 Reserved
F06.14
No weighing current coefficient
0－9999【3000】
F06.15 No weighing speed-loop KP 1
－
9999
【
2000
】
F06.16
No weighing speed-loop KI
1－9999【2000】
F06.14－F06.16 are used to adjust the effect of no weighing auto-compensation (F06.00 = 4).
• The system’s response can be expedited through increasing F06.14－F0616, but system’s
oscillation and overshoot may occur if the value of F06.14－F0616 is too high.
• Generally, it can smoothly start elevator via adjusting F06.14 when debugging.
• Increase F06.14 so as to avoid sliding vehicle at starting moment. Decrease F06.17 so as to
avoid shake at starting moment.
F06.17－F06.20 Reserved
6.2.8 Group F07 Asynchronous Motor Parameters
The relationship among rated torque current, excitation current and motor’s rated current is as
follows:
Rated torque current = F07.05 × F07.02
Excitation current F07.11 =
�
1 − F07.05
2
× F07.02
Mutual inductance F07.10 =
F07.01
2
√
3
π × F07.03 × F07.11
− F07.09
Code Name Description Range
【
factory setting
】
F07.00 Asynchronous motor rated power 0.2
－
400.0kW
【Depend on controller model】
F07.01 Asynchronous motor rated voltage 0V
－
Controller rated voltage
【
Depend on controller model
】
F07.02 Asynchronous motor rated current 0.0
－
999.9A
【Depend on controller model】
F07.03 Asynchronous motor rated frequency 1.00
－
100.00
【
50.00Hz
】
F07.04
Asynchronous motor rated Rpm
1－24000【1440rpm】
I1
I2
Io
R1 R2Ll Ll
L m
U1
R2
1 - S
S
R1 = F07.07 (Stator resistance) Ll = F07.09 (Leakage inductance)
R2 = F07.08 (Rotor resistance) Lm = F07.10 (Mutual inductance)
Io = F07.11 (Excitation current) S = Slip ratio

hpmont HD5L series Specifications

General

Brand	hpmont
Model	HD5L series
Category	Controller
Language	English