HS-Technik NutBee NBPS-21 - Page 57

- 57 -
- „shidown point“
Species the force from which the seng speed is to be reduced.
Only available in the „rpm + force“ control mode.
„stop mode“ In the drop-down menu, it is possible to choose between „No stop“ for
switching between two steps and „ECO stop“ for the last step.
The parameter for rivet seng are dened in the „Strategy“ tab.
The individual funcons can be acvated by clicking on the On/O symbol. A green symbol
means acve, greyed out means inacve.
NBPS-21
stroke
„S
target
“ S
Target
describes the stroke that the tool should travel in this step. When
this value is reached, the tool changes to the next step.
„S
limit
“ S
Limit
describes the max. stroke the tool may cover in this step. When
this value is reached, the tool stops and displays an NOK error message.
current
„I
target
“ I
Target
describes the current that the tool should reach in this step. When
this value is reached, the tool changes to the next step.