HS-Technik NutBee NBPS-21 User Manual

- 56 -
The sengs for speed and pulling direcon are made in the „Gear“ tab.
„stroke“ The direcon of the stroke is parametrised here. The default is „Pulling
direcon“. The „Start posion“ seng is only required for special ap-
plicaons. If you have any quesons, please contact our support team:
support@hs-technik.com
„start-up ramp“ This me denes the ramp with which the motor moves to the target
speed, recommended value 0.1 - 0.2 seconds.
„control method“ Adjustment of the engine control. „Set rpm“ is the default seng. In the
„regulate rpm“ control mode, the tool keeps the speed constant even
under load.
- „regulate rpm“
The speed control corresponds to a closed control loop. The tool will
try to maintain the set speed even under load.
- „set rpm“
The speed control corresponds to an open control loop. The tool will
not readjust the speed under load.
- „rpm + force“
The speed control is dependent on the measured force. Only possible
when F
Target
(NBPF-25) is acvated
- „seng speed
Target
“
Adjustment of the seng speed in %. Recommended seng for
screwing-on, level 1, 50 %, for seng, level 2, 80 - 100 %.
- „seng speed
min
“
Adjustment of the minimum seng speed

HS-Technik NutBee NBPS-21 Specifications

General

Brand	HS-Technik
Model	NutBee NBPS-21
Category	Rivet Tools
Language	English