Huawei B2268H - Page 37

LTE TDD B2268H
User Guide
5 Wireless
Issue 01 (2014-01-15)
Copyright © Huawei Technologies Co., Ltd.
30
Figure 5-2 Network Setting >Wireless>General
The following table describes the labels in this screen.
Table 5-1 Network > Wireless LAN > General
LABEL
DESCRIPTION
Wireless Network Setup
Wireless
Select the Enable Wireless LAN check box to activate the wireless
LAN.
Wireless Network Settings
Wireless
Network Name
(SSID)
The SSID (Service Set IDentity) identifies the service set with which a
wireless device is associated. Wireless devices associating to the access
point (AP) must have the same SSID.
Enter a descriptive name (up to 32 English keyboard characters) for the
wireless LAN.
Hide SSID
Select this check box to hide the SSID in the outgoing beacon frame so a
station cannot obtain the SSID through scanning using a site survey tool.
BSSID
This shows the MAC address of the wireless interface on the LTE Device
when wireless LAN is enabled.
Mode Select
This makes sure that only compliant WLAN devices can associate with
the
LTE Device.
Select 802.11b/g/n to allow IEEE802.11b, IEEE802.11g and
IEEE802.11n compliant WLAN devices to associate with the LTE
Device. The transmission rate of your LTE Device might be reduced.
Select 802.11b/g to allow both IEEE802.11b and IEEE802.11g
compliant WLAN devices to associate with the LTE Device. The
transmission rate of your LTE Device might be reduced.
Select 802.11g Only to allow only IEEE 802.11g compliant WLAN
devices to associate with the LTE Device. Select 802.11n only in 2.4G