LTE TDD B2268H
User Guide
Copyright © Huawei Technologies Co., Ltd.
band to allow only IEEE 802.11n compliant WLAN devices with the
same frequency range (2.4 GHz) to associate with the LTE Device.
Set the channel depending on your particular region.
Select a channel or use Auto to have the LTE Device automatically
determine a channel to use. If you are having problems with wireless
interference, changing the channel may help. Try to use a channel that is
as many channels away from any channels used by neighboring APs as
possible. The channel number which the LTE Device is currently using
then displays in the Operating Channel field.
This is the channel currently being used by your AP.
Select Basic or More Secure to add security on this wireless network.
The wireless clients which want to associate to this network must have
same wireless security settings as the LTE Device. When you select to
use a security, additional options appears in this screen.
Or you can select No Security to allow any client to associate this
network without any data encryption or authentication.
See the following sections for more details about wireless security modes.
Click Apply to save your changes back to the LTE Device.
Click Cancel to restore your previously saved settings.
No Security
Select No Security to allow wireless stations to communicate with the access points without any data
encryption or authentication.
If you do not enable any wireless security on your LTE Device, your network is accessible to any
wireless networking device that is within range.
Figure 5-3 Wireless> General: No Security
The following table describes the labels in this screen.
To Next Page
Loading...
