Installation Manual
Quidway S2000-EI Series Ethernet Switches Chapter 4 Powering on Switch for the First Time
4-6
Note:
The boot display may change according to different switches. The display of S2403H-EI Switch is shown
in the following example.
Starting...
**********************************************
* *
* Quidway S2403H-EI BOOTROM, Version 120 *
* *
**********************************************
Copyright(C) 2003-2004 by HUAWEI TECHNOLOGIES CO.,LTD.
Creation Date : Mar 17 2004, 18:05:26
CPU Type : ARM
CPU Clock Speed : 50MHz
Memory Size : 32MB
Initialize LS41LTSU ......................OK! (1)
SDRAM selftest............................OK! (2)
FLASH selftest............................OK! (3)
Slot 1/1 has 100M_EP Selftest OK (4)
Slot 2/1 has no module or get slot type error (5)
PHY selftest..............................OK! (6)
Please check port leds..............finished! (7)
The switch Mac is: 00E0-FC00-0010 (8)
Press Ctrl-B to enter Boot Menu... 5
Line (1) through line (8) are self test information of the system.
Line (4) and (5) are the information about the optional modules installed on the rear
panel and can be different for different modules.
Line (8) asks if the user will enter the BOOT menu and prompts 5 seconds of waiting.
z Press <Ctrl+B> within 5 seconds and enter the BOOT menu.
z If you perform no operation or press other keys other than <Ctrl+B> within the 5
seconds of waiting, the system will enter the auto-booting state when the time
prompt for instruction waiting becomes 0.
System auto-booting interface is as follow:
Auto-booting...
Decompress Image. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To Next Page
Loading...
Need help?
General