Huawei Quidway S2000-EI Series

Installation Manual
Quidway S2000-EI Series Ethernet Switches Chapter 4 Powering on Switch for the First Time
4-7
. . . . . ..OK!
Starting application now......
User interface Aux0/0 is available
Press ENTER to get started.
The above information indicates the automatic booting is done.
Press <Enter> and the terminal yields the following output:
<Quidway>
By this time, a user can start configuring the switch.
 Note:
Quidway series switches provide rich command modes. For introduction of the configuration commands
and command line interfaces in detail, refer to Quidway S2000-EI Series Ethernet Switches Operation
Manual.