Step 11 To complete the assembly of the other end, repeat steps 1 to 10.
----End
Assembling an Unshielded RJ45 Connector and Ethernet Cable
Context
Figure 13-28 shows the components of an unshielded RJ45 connector and cable.
Figure 13-28 Components of an unshielded RJ45 connector and cable
A. Plug of connector B. Jacket C. Twisted-pair wires
Procedure
Step 1 Remove a 16-mm (0.63 in.) long section of the jacket, as shown in Figure 13-29.
NOTICE
When you remove the shield layer, do not damage the insulation of the twisted-pair cable.
Figure 13-29 Removing the jacket of a twisted-pair cable (unit: mm (in.))
Step 2 Align the four pairs of wires and cut the ends neatly, as shown in Figure 13-30. The
connections between the wires and the pins are listed in Table 13-23.
S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
13 Appendix
Issue 13 (2017-11-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
116
To Next Page
Loading...
