Huawei S2700 - Page 52

NOTE
The ground cable is included in the installation accessory package.
Procedure
Step 1 Wear an ESD wrist strap or ESD gloves. When wearing an ESD wrist strap, ensure that it is in
close contact with your wrist and grounded properly.
Step 2 Use a Phillips screwdriver to remove the M4 screw from the ground point on the switch, as
shown in Figure 5-21. Keep the M4 screw for later use.
Figure 5-21 Removing the M4 screw from the ground point
Step 3 Attach the M4 lug of the ground cable to the ground point on the switch with the M4 screw
you removed in step 2. See Figure 5-22.
NOTE
The ground cable has an M4 lug at one end and an M6 lug at the other end. The M4 lug is the smaller of
the two.
Figure 5-22 Connecting the ground cable to the switch
S2700&S3700&S5700&S6700 Switch
Hardware Installation and Maintenance Guide
5 Installing a Switch
Issue 13 (2017-11-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
44