l If the settings of the DIP switch on the EPS30-4815AF are different from the settings of
the secondary nodes of the EMU on the MA5612, go to Step 8.
Step 8 Set the DIP switch on the EPS30-4815AF or run the emu add command to configure the
secondary nodes of the EMU on the MA5612 again so that the settings of the DIP switch on the
EPS30-4815AF are the same as the settings of the secondary nodes of the EMU on the
MA5612. Run the display emu command to check whether the EPS30-4815AF is in Normal
state.
l If the EPS30-4815AF is in Normal state, go to Step 10.
l If the EPS30-4815AF is not in Normal state, go to Step 9.
Step 9 Record the results of the preceding steps in a fault report (see Fault Report Form), fill out the
entire form, and then submit it to Huawei for technical support (see Contacting Huawei for
Assistance).
Step 10 End.
----End
SmartAX MA5612 Multi-service Access Module
Maintenance Guide 7 Troubleshooting EMU Faults
Issue 01 (2012-07-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
243
To Next Page
Loading...
