41
Figure 4-20 Add REDIRECT rule
II.
Parameter explanation
The explanation of parameters in the above windows is as
below.
NAT Configuration:
z
Rule ID: The Rule ID determines the order in which rules
are invoked (the lowest numbered rule is invoked first, and
so on). In some cases, two or more rules may be defined to
act on the same set of IP addresses. Be sure to assign the
Rule ID so that the higher priority rules are invoked before
lower-priority rules. It is recommended that you select rule
IDs as multiples of 5 or 10 so that, in the future, you can
insert a rule between two existing rules.
z
IF Name: Displays the name of the interface.
z
Rule Flavor: There are three rules you can select:
REDIRECT, DMZ, and NAPT.
To Next Page
Loading...
