Huawei SmartAX MT800 - Page 52

42
z
Protocol: This selection specifies which type of Internet
communication will be subject to this translation rule. You
can select TCP or UDP.
z
Local IP From: Type the starting IP of the range of private
address you want to be translated. You can specify that
data from all LAN addresses should be translated by typing
0 (zero) in each From field and 255 in each To field. Or,
type the same address in both fields if the rule only applies
to one LAN computer.
z
Local IP To: Type the ending IP of the range of private
address you want to be translated.
z
Action: Check or delete the rule.
Add NAPT Rule:
z
Local IP From: Type the starting IP of the range of private
address you want to be translated. You can specify that
data from all LAN addresses should be translated by typing
0 (zero) in each From field and 255 in each To field. Or,
type the same address in both fields if the rule only applies
to one LAN computer.
z
Local IP To: Type the ending IP of the range of private
address you want to be translated.
Add DMZ Rule:
z
Local IP: Type the private IP address you want to be
translated.
Add REDIRECT Rule:
z
Protocol: This selection specifies which type of Internet
communication will be subject to this translation rule. You
can select TCP or UDP.
z
Local IP: Type the private IP address you want to be
translated.