Installing the Chassis Cover
Step 1 Wear an ESD wrist strap. For details, see 5.2 ESD Protection.
Step 2 Position the cover horizontally, align it with the xing slots on both side panels of
the chassis, and close the handle. See (1) and (2) in Figure 5-34.
Figure 5-34 Installing the chassis cover
Step 3 Tighten the screw using a Phillips screwdriver to secure the handle. See (3) in
Figure 5-34.
Step 4 Install the server. For details, see 5.4.3 Installing the Server on Guide Rails.
Step 5 Connect the power cables. For details, see 5.7 PSU.
Step 6 Power on the server. For details, see 5.4.1 Powering On the Server.
----End
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 102
To Next Page
Loading...
