Step 3 Remove the power cables. For details, see 5.7 PSU.
Step 4 Remove the server. For details, see 5.4.4 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 5.8 Chassis Cover.
Step 6 Remove the drive module or riser module above the battery. For details about
how to remove a drive module, see 5.19.1 2 x 3.5-inch Rear Drive Module. For
details about how to remove a riser module, see 5.11 Riser Module.
Step 7 Pull up the right end of the battery and remove it from the slot. See Figure 5-59.
Figure 5-59 Removing the battery
Step 8
Place the removed battery in an ESD bag.
----End
Installing the Battery
Step 1 Wear an ESD wrist strap. For details, see 5.2 ESD Protection.
Step 2 Power o the server. For details, see 5.4.2 Powering O the Server.
Step 3 Remove the power cables. For details, see 5.7 PSU.
Step 4 Remove the server. For details, see 5.4.4 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 5.8 Chassis Cover.
Step 6 Remove the drive module or riser module above the battery. For details about
how to remove a drive module, see 5.19.1 2 x 3.5-inch Rear Drive Module. For
details about how to remove a riser module, see 5.11 Riser Module.
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 122
To Next Page
Loading...
