Huawei TaiShan 200 2280 - Page 153

Figure 5-87 Removing a rear drive assembly
Step 9 Lift the rear drive assembly. See (2) in Figure 5-87.
Step 10 Place the removed drive assembly in an ESD bag.
----End
Installing a Rear Drive Module
Step 1 Wear an ESD wrist strap. For details, see 5.2 ESD Protection.
Step 2 Power
o the server. For details, see 5.4.2 Powering O the Server.
Step 3 Remove the power cables. For details, see 5.7 PSU.
Step 4 Remove the server. For details, see 5.4.4 Removing the Server and Guide Rails.
Step 5 Remove the chassis cover. For details, see 5.8 Chassis Cover.
Step 6 Take a spare drive assembly out of its ESD bag.
Step 7 Install the rear drive assembly in the chassis and tighten the screws. See Figure
5-88.
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 146