Figure 5-92 Removing the right mounting ear plate
Step 6 Take out the right mounting ear plate. See (3) in Figure 5-92.
Step 7 Remove the signal cable from the right mounting ear plate.
Step 8 Place the removed right mounting ear plate in an ESD bag.
----End
Installing the Right Mounting Ear Plate
Step 1 Wear an ESD wrist strap. For details, see 5.2 ESD Protection.
Step 2 Power
o the server. For details, see 5.4.2 Powering O the Server.
Step 3 Remove the power cables. For details, see 5.7 PSU.
Step 4 Remove the server. For details, see 5.4.4 Removing the Server and Guide Rails.
Step 5 Take a spare right mounting ear out of its ESD bag.
Step 6 Connect the signal cable to the right mounting ear.
TaiShan 200 Server
Maintenance and Service Guide (Model 2280) 5 Removal and Installation
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 151
To Next Page
Loading...
