Pub. 42004-550A
Elemec3 Console Manual—Version 3.0 Page 30 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
2. Assign hex addresses 0–3 to type I cards. Assign hex addresses 4–7 to type II cards.
The columns in the ACCESS PANEL INTERFACES SUMMARY screen display the address assigned to
the card after defining the card type. Column one corresponds to 0x0 and 0x4, column two represents
addresses 0x1 and 0x5, and so on.
3. Click ◄BACK to return to the SYSTEM PROPERTIES screen.
4. Click ACCESS PANEL BUTTON TEMPLATE to configure the button template layout.
The button template defines the default button layout for the physical access panels in the Elemec3
system (see the Access Panel Button Configuration section).
Add Access Panels
The ADD ACCESS PANEL screen opens when an API card is first enabled or by clicking the ADD ACCESS
PANEL button from the ACCESS PANEL INTERFACES SUMMARY screen.
Figure 32. Add Access Panel
1. Select the type of access panel to add and click ADD DEVICE.
• The access panel appears under the API on the ACCESS PANEL INTERFACES screen.
• An ADD ACCESS PANEL button appears under each API after defining the first access panel for that
API.
2. Select the SET AS DEFAULT checkbox to skip the AP selection screen if the remaining access panels
are the same type.
To Next Page
Loading...
