GETTING STARTED 3
Decal 128-1117-2 shows the FDA performance standards
compliance.
Figure 1.
The red “STOP” button, can be used for emergency
stops.
Never reach under the hood while the
balancer is performing a balance spin.
SAVE THESE INSTRUCTIONS
Electrical
The Hunter SmartWeight Touch® and GSP9200 Touch
Balancer are manufactured to operate at a specific
voltage and amperage rating.
Make sure that the appropriate electrical supply circuit is
of the same voltage and amperage ratings as marked on
the balancer.
DO NOT ALTER THE ELECTRICAL PLUG.
Plugging the electrical plug into an unsuitable
supply circuit will damage the equipment.
Make sure that the electrical supply circuit and the
appropriate receptacle is installed with proper grounding.
To prevent the possibility of electrical shock injury or
damage to the equipment when servicing the balancer,
power must be disconnected by removing the power cord
from the electrical power outlet.
After servicing, be sure the balancer ON/OFF switch is in
the “O” (off) position before plugging the power cord into
the electrical power outlet.
This device is rated as Class A for radiated emissions.
In the event of radio interference, the display read out
may flicker - this is normal.
Decal Information and Placement
Right Side View
Decal 128-1244-2 cautions the operator that spindle
rotation may occur with foot pedal depression and
to keep clear of clamping components during Quick-
Thread® shaft rotation.
Decal 128-1234-2 gives the maximum wheel diameter
and maximum wheel weight for the SmartWeight Touch
®
/
GSP9200 Touch.
Decal 128-116-2 warns the operator not to view the laser
light with optical instruments.
To Next Page
Loading...
