Hunter SmartWeight Touch - Static Balancing - Traditional Balancing Mode; Switching from Traditional Dynamic Balancing to Traditional Static Balancing; Blinding and Rounding

34 BALANCING PROCEDURES
Dynamic mode, blinding/rounding is disabled:
Figure 120.
Static mode, blinding/rounding is enabled:
Figure 121.
Static Balancing – Traditional Balancing
Mode
Enter wheel dimensions before selecting
dynamic balancing. If SmartWeight® mode is
enabled in setup, the balancer will return to
SmartWeight® balancing upon dimension entry.
Static balancing provides a less desirable balance
than dynamic balancing. Dynamic balancing should be
selected whenever possible to minimize vehicle vibration.
Switching from Traditional Dynamic Balancing
to Traditional Static Balancing.
In non-SmartWeight® mode, the balancer can be
switched from dynamic balancing to static balancing.
Dynamic mode is selected:
Figure 118.
Touching the static mode icon will switch to static mode.
Figure 119.
Blinding and Rounding
In non-SmartWeight® mode, the balancer can display
either an “actual” or “blinded and rounded” amount of
imbalance.
Touching the magnifying glass icon next to the dynamic
or static icons will toggle blinding and rounding on or off.