BALANCING PROCEDURES 31
The panel can be further expanded to show detailed
information for up to the last eight wheel assemblies
balanced. (Figure 101.)
Figure 101.
Print Summary
A printout is available that incorporates a detailed image
of each wheel assembly with the stored measurements.
If a measured value is out of tolerance compared to the
recalled specification, the value will be printed in red.
From the main balance screen, select “Print”.
Figure 102.
From the drop down menu, select “Vehicle Summary”.
Figure 103.
The Vehicle Summary screen will be displayed.
Figure 104.
3.7 Wheel Assembly Selection for
Saving Spin Data
Saving Spin Data
The SmartWeight Touch®/GSP9200 Touch automatically
tracks the wheel assembly currently being balanced.
The balancer assumes that the technician is working
“around the vehicle” by beginning at the LEFT FRONT
and working around the vehicle in a clockwise fashion.
Successive spins are stored as either “before” or “after”
data based on the following rules:
• If the weight displays read “OK/OK” or is blank,
assume the next complete spin is “before” data.
Figure 99.
• If the weight displays read anything other than “OK/
OK” or is blank, assume the next complete spin is
“after” data.
Measurement Storage
The SmartWeight Touch®/GSP9200 Touch automatically
tracks the wheel assemblies as they are balanced.
As the wheel assemblies are balanced, their status can
be viewed as they would appear on the vehicle currently
being serviced. Select the VirtualView® button to expand
the VirtualView® panel.
Figure 100.
To Next Page
Loading...
