64 EQUIPMENT INFORMATION
Figure 269.
Diagnostics
From the main balance screen, touch the “Tools” button.
Figure 270.
Touch the “Advanced” button.
Figure 271.
Touch the “Diagnostics” button.
Figure 272.
The main Diagnostics screen is displayed.
Figure 273.
Select the desired diagnostic procedure and follow the
on-screen instructions.
Calibration Procedures
Using calibration procedures, the operator can calibrate
the following systems:
• Inner Dataset
• Outer Dataset
The operator can also perform a 3 Spin Balancer
Calibration and check calibration of any of the systems.
From the main balance screen, touch the “Tools” button.
Figure 265.
Touch the “Advanced” button.
Figure 266.
Touch the “Calibration Procedures” button.
Figure 267.
The main Calibration Procedures screen is displayed.
Figure 268.
Select the desired calibration procedure and follow the
on-screen instructions.
To Next Page
Loading...
