36 BALANCING PROCEDURES
Dimensions Entry - Outer Clip
Pulling out only the outer Dataset® arm after already
measuring an inner clip dimension signals to the balancer
that the operator wants to measure an outer plane clip
dimension.
Figure 130.
Dimensions Entry - Inner and Outer Clip
Pulling out both the inner and outer Dataset® arms
and placing them in the clip-clip position signals to the
balancer that the operator wants to measure inner and
outer plane clip dimensions.
Figure 131.
Balancing Procedure Using Clip-On Weights
Figure 132.
Dimensions Entry - Outer Tape
Pulling out only the inner Dataset® arm, pointing
it down and pressing on the foot pedal records the
first dimension. Since the Dataset® arm is still in the
down position, this signals to the balancer that the
operator wants to measure the second inner plane tape
dimension.
Figure 128.
Dimensions Entry - Enter Spoke(s)
Entering an outer plane tape dimension will prompt
operator to enter spoke positions so that tape weight(s)
can be hidden behind spoke(s).
Figure 129.
The operator can enter the spoke(s) location(s) or return
the Dataset® arm to its home position to cancel spoke
location entry.
To Next Page
Loading...
