Hunter SmartWeight Touch - Left Side View; Back View; Specific Precautions;Power Source

4 GETTING STARTED
Back View
Decal 128-381-2 warns the operator not to remove
the cover of the SmartWeight Touch/GSP9200 Touch
because of the risk of electrical shock and not to use
below garage floor level.
Decal 128-1120-2 shows ETL listing and cautions not to
use below garage floor level.
WARNING
TO PREVENT THE RISK
OF ELECTRIC SHOC K
DO NOT REMOVE
COVER. NO USER
SERV ICEABLE PA RT S
INSIDE. REFER TO
QUALIFIED SERVICE
PERSONNEL.
128-381-2
!
CAUTION:
DO NOTUSE
BELOWGARAGEFLOORLEVEL
ATTENTION: NE PA SUTILISER
AUNNIVEAUINFERIEURA
CELU IDUPLANCHE RDU
GARAGE OU DU SQL.
CONFORMS TO
UL STD 201
CERTIFIED TO
CAN/CSA STD C22.2 NO. 68-92
ETLLISTED
3091212
128-1120-2
128-381-2
128-1 120-2
Figure 3.
Specific Precautions/Power Source
The SmartWeight Touch®/GSP9200 Touch Balancer is
intended to operate from a power source that will apply
230VAC +10% / -15%, 1 phase, 10 amp 50/60 Hz, power
cable includes NEMA 20 amp plug, L6-20P, between the
supply conductors of the power cord. The power cord
supplied utilizes a twist lock connector, NEMA L6-20P.
(Figure 4.) This machine must be connected to a 20 amp
branch circuit. Please refer all power source issues to a
certified electrician. Refer to “Installation Instructions for
SmartWeight Touch® Balancer,” Form 6423-T.
Left Side View
(Figure 2.)Decal 128-391-2-00 cautions that the unit may
automatically start upon closing of the hood when hood
Autostart is enabled.
!
WA R
NI
N
G
MA
Y S
TAR T
A
U
T
O
M
A
T
I
C
A
L
L
Y
UP
ON
HO
O
D
CL
O
S
I
N
G
1
2
8
-
3
9
1
-
2
-0
0
128-391-2-00
Figure 2.