CALIBRATION AND MAINTENANCE 73
Spindle Hub Face and Shaft
Keep the shaft and wing nut threads clean and lubricated.
Lubricate the shaft without contaminating the hub face.
Run the edge of a rag between the threads while the
spindle is slowly turned by the motor drive. If any signs of
dirt or debris appear on the spindle threads, the spindle
should be cleaned immediately prior to mounting a wheel.
Failure to clean spindle properly will result in a
loss of clamping force.
Lubricate the shaft with a coating of light lubricant with
Teflon® such as Super Lube® by Loctite after cleaning.
Do not lubricate the spindle hub face mounting surface.
This could cause slipping between the wheel and the hub
face. Keep the hub face mounting surface clean and dry.
BDC Laser Adhesive Weight Locator
Maintenance or Service
Use of controls or adjustments or
performance of procedures other than
those specified herein may result in
hazardous radiation exposure.
This Laser Product is designated as Class 1M during all
procedures of operation.
Never look directly into the laser. Doing so may cause
serious injury.
Do not intentional use a reflective device to enhance or
re-direct the laser.
Do not operate the laser if the cover or seal is damaged.
There is no required maintenance or service to keep the
BDC Laser in compliance.
Any necessary repair or maintenance should be done
by the factory only. The BDC Laser Locator has no field
serviceable parts.
The unit should never be opened or modified.
5.3 Cleaning the Console
When cleaning the console, use window cleaning solution
to wipe off the display console and cabinet. Do not spray
window cleaning solution directly onto LCD. Power should
be “OFF” prior to cleaning the LCD.
Exposing the balancer to water either by
hose, bucket, or weather may cause risk of
electrical shock to operator or bystanders
and will damage the electrical system.
Place, store, and operate the balancer only
in a dry, sheltered location.
Cleaning the Screen
Do not touch the screen with chemicals or
solvents on fingers, i.e. brake cleaner. Doing
so will damage the anti-glare protector on the
screen.
Safety Instructions
• Please keep the display away from any heat sources
such as electric radiators or direct sunlight. Place the
display in a stable and well-ventilated place.
• The holes or openings on the display are designed
for ventilation. Do not cover or block the ventilation
holes or openings with any objects.
• As the display surface is vulnerable to scratches,
avoid touching the surface with nail or pen point.
• Shut off the power supply before cleaning. Use a soft
lint-free cloth instead of a tissue to wipe the screen.
• You may use a glass cleaner to clean the product as
required. However, never spray the cleaner directly
onto the display surface.
• Do not attempt to repair this product yourself!
Improperly disassembly of the product may expose
you to danger! If your problem cannot be solved
according to the “Troubleshooting” guidelines, contact
your regional HP authorized service provider, http://
www.hp.com/support.
To maintain a brand new appearance of the display, clean
with soft cloth regularly. Please remove stubborn stains
with soft cleaner rather than strong cleaners such as
diluting agent, benzene or corrosive cleaner as they may
damage the display. For the sake of safety, remove the
power plug prior to cleaning.
ArmorAll wipes are a suitable cleaning product for the
touch screen.
To Next Page
Loading...
