13
The controller will water the selected program at the next
start time and will then water at the interval programmed.
Setting Event Day(s) O
The XC allows you to program a No Water Day(s). This
feature is useful to inhibit watering on specic day(s). For
example, if you always mow the lawn on Saturdays, you
would designate Saturday as a No Water Day so that you
are not mowing wet grass.
1. Turn the dial to the WATER DAYS position.
2. Enter an interval watering schedule as described
previously on this page.
3. Press the
button to scroll to the NO WATER DAYS at the
bottom of the display. MO will be ashing.
4. Use the
button until the cursor is at the day of the week
you wish to set as a No Water Day.
5. Press the
button to set this day as a no water day. The
will illuminate over this day.
6. Repeat steps 4 and 5 until all desired event day(s) are o.
NOTE: You also have the option in the interval watering
schedule to program Odd or Even days o.
Selecting Odd or Even Days to Water
This feature uses numbered day(s) of the month for watering
instead of specic days of the week (odd days: 1st, 3rd, 5th,
etc.; even days: 2nd, 4th, 6th, etc.).
1. With the
cursor on Su, press the
button once. The
icon and odd will
be displayed.
2. If odd day watering is desired, turn
the dial back to the run position.
3. If even day watering is desired, press
the
button once. The icon and
EVEN will be displayed. You can move
back and forth from ODD to EVEN by
pressing the
and buttons.
NOTE: The 31st of any month and February 29th are
always “o” days if Odd watering is selected.
Selecting Interval Watering
With this option you can select interval
watering from 1 to 31 days.
1. With the cursor on EVEN, press the
button once and the
icon will appear
and a 1 ashing in the display. Interval
watering schedule appears on the display.
2. Press the
or button to select the
number of days between watering days
(from 1 to 31 days). This is called the interval.
PROGRAMMING THE CONTROLLER
Even
2, 4,...30
Odd Day Watering
Even Day Watering