15
Manually Run a Single Station
1
1. Turn the dial to MANUAL – ONE
STATION position.
2. Station run time will ash in the display.
Use the
button to move to the desired
station. You may use the
or button
to select the amount of time for a station
to water.
3. Turn the dial clockwise to the RUN position to run
the station (only the designated station will water,
then the controller will return to automatic mode
with no change to the previously set program).
Also see One Touch Start and Advance.
Manually Run All Stations
ALL
1. Turn dial to MANUAL – ALL
STATIONS position.
2. Select program A, B, or C by pressing the
button.
3. Station run time will ash in the display. Use the
or button to select the amount of time for
a station to water if dierent from the run time
displayed.
4. Use the
button to move to the next station.
5. Repeat steps 3 and 4 to customize each station.
6. Press the
button until you reach the station at
which you would like watering to begin.
PROGRAMMING THE CONTROLLER
Turn the dial clockwise to the RUN position (the
controller will water the entire program beginning with
the station number last le in the display, then return
to the automatic mode with no change in the previously
set program).
One Touch Manual Start and Advance
You can also activate all stations to water without using
the dial.
1. Hold down the
button for 2 seconds.
2. This feature automatically defaults to program A. You
can select program B or C by pressing the
button.
3. The station number will be ashing. Press the
button to scroll through the stations and use the
or
button to adjust station run times. (If no buttons
are pressed for a few seconds during step 2 or 3, the
controller will automatically begin watering).
4. Press the
button scroll to the station you wish to
begin with. Aer a 2-second pause, the program will
begin. At any time during the manual cycle, you can
use the
or buttons to navigate from station to
station manually.
To Next Page
Loading...
