Hunter XC Hybrid - Program Memory, Test Program, and Station Delays

17
ADVANCED FEATURES
Easy Retrieve
™
Program Memory
The XC Hybrid is capable of saving the preferred watering
program into memory for retrieval at a later time. This
feature allows for a quick way of resetting the controller
to the original programmed watering schedule.
To save the program into the memory
1. With the dial in the RUN position, press and hold the
and buttons for 5 seconds. The display will scroll
three segments
from le to right across the display
indicating the program is being saved into memory.
2. Release the
and buttons.
To retrieve a program that was previously saved into
memory.
1. With the dial in the RUN position, press and hold the
and buttons for 5 seconds. The display will scroll
three segments
from right to le across the display
indicating the program is being saved into memory.
2. Release the
and buttons.
Programmable Delay Between Stations
This feature allows the user to insert a delay between
stations between when one station turns o and the next
one turns on.
1. Start with the dial in the RUN position.
2. Press and hold the
button down while turning the dial
to the RUN TIMES position.
3. Release the
button. At this point the display will show
a delay time for all stations in seconds, which will be
ashing.
4. Press the
or buttons to increase or decrease the
delay time between 20 seconds and 4 hours.
5. Return the dial to the RUN position.
Clearing the Controller's Memory/Resetting
the Controller
If you feel you have misprogrammed the controller, there
is a process that will reset the memory to the factory
defaults and erase all programs and data that have been
entered into the controller.
1. Press and hold down the
button.
2. Press and release the reset button in the lower
wiring compartment.
3. Wait 2 seconds and release the
button. The display
should now show 12:00
AM. All the memory has been
cleared and the controller may now be reprogrammed.