18 – English
NOTE!
After repairing, the chain brake must be
inspected in line with the instruction below.
6.2 Assembling the chain brake
1
Screw the knee joint and the brake band together
(see gure 5) with a tightening torque of 1-1.5 Nm.
Place the knee joint with the tted chain brake
band in the opening in the clutch cover. The space
for the spring in the cover must be lubricated with
grease. See gure. 6.
2
Compress the springs with a wide screwdriver or
special tool 502 50 67-01. See gure 7.
3
Fit the cover over the brake spring using 1-1.5 Nm
tightening torque. See gure 8.
WARNING!
Exercise care to ensure the spring
does not fly out and causes
personal injury. Wear protective
goggles.
4
Tighten the brake by using the saw's hand
guard as a tool. Mesh with the brake and tighten
clockwise until the brake is in the off position.
See gure 9.
Fit the:
• bar
• chain
• hand guard
• clutch cover
• cylinder cover
Safety equipment
Fig 6
Fig 8
Fig 9
Fig 7
To Next Page
Loading...
