Husqvarna 455 Rancher II - Working Techniques; Before use:; General working instructions

English – 23
6.11 Assembling the throttle lock, throttle
control and spring
1
Attach the spring to the throttle as outlined in
gure 21. Ensure correct positioning of the spring
by fastening one end to the triangular recess in the
throttle.
Safety equipment
Fig 22
Fig 23
2
Attach the throttle to the handle. Place the spring
in the rear recess of the throttle lock. Attach the
throttle lock to the handle.
Note! The long hook of the spring is to pass to the
left of the throttle lock. See gure 22.
3
Assemble the handle half with the screws. See
gure 23. Tightening torque 4-5 Nm.
Fig 21