30 – English
Repair Instructions
4
Carefully loosen the clutch springs with a
screwdriver as outlined in gure 16.
NOTE!
Be careful with the clutch springs, as
opening them too much can result in
material damage.
Cleaning and inspection
• Clean and check all parts carefully. Parts must
be replaced if cracked or showing signs of
other defects. Always use original spare parts.
• Check the thickness of the clutch shoes by
measuring them with slide calipers across the
whole clutch hub. If the thickness is below 65
mm, the entire clutch must be replaced. See
Figure 17.
2
Loosen the spark plug hat and remove the spark
plug, and insert the plastic piston stop
(504 91 06-05). See gure 14.
3
Loosen the clutch using tool 502 54 16-01 and a
suitable socket wrench or combination spanner.
See gure 14. Turn the clutch clockwise to
loosen it.
7.8 Dismantling the centrifugal clutch
1
Release the brake by moving the hand guard
backwards. Remove the cylinder cover, the clutch
cover, the chain and the bar.
Fig 14
Fig 15
Fig 17
Min 65mm
Fig 16
To Next Page
Loading...
