34 – English
Repair Instructions
7.13 Assembling the intake system
1
Assemble the carburetor ange on the intake
bellows. Fit the impulse hose, intake bellows and
partition wall on the cylinder. See gure 26.
2
Place a new cylinder pedestal gasket on the cylin-
der. See gure 26b.
3
Fit the cylinder. The screws (4x) must be tightened
crosswise with a tightening torque of 13-15 Nm.
4
Fit the handle system and hand guard.
5
Fit the carburetor, the lter holder and the air lter
as outlined in “Assembling the carburetor”.
Fig 26
Fig 26b
To Next Page
Loading...
