22 – English
Safety equipment
6.10 Dismantling the throttle lock, throttle
control and spring
1
Dismantle the rear handle screws (3) and loosen
the handle half. See gure 18.
Cleaning and inspection
• Carefully clean and check all parts. See gure 20.
Parts must be replaced if cracked or showing
signs of other defects. Always use original spare
parts.
• Check that the spring is intact and retains all its
tension.
Fig 19
Fig 20
Fig 18
2
Loosen the throttle lockout from the handle and
then dismantle the spring and throttle.
See gure 19.
To Next Page
Loading...
