English – 29
Repair Instructions
7.7 Assembling the ignition module and
flywheel
1
Put the ignition module into position. Put the
cable through the hole in the crankcase and plug
in the connector. Fasten the ignition lead to the
attachment on the partition wall. See gure 11.
Fig 12
Fig 13
Air gap tool
4
Fit the ywheel onto the crankshaft journal. Turn
the ywheel until the key ts into the key slot on
the shaft. See gure 12.
Tighten the nut. Tightening torque 22-25 Nm
5
Place the 0.3 +- 0.1 mm feeler gage, 502 51 34-02,
between the lugs on the ignition module and ywheel.
Turn the ywheel so that the magnets are positioned
opposite the ignition module. Tighten the screws,
tightening torque 4-6 Nm. Remove the plastic air gap
tool.
6
Then t:
• the guide rail and press the cable in place
• the spark plug cap
•
the starter, tightening torque 2.5-3.5 Nm
• the cylinder cover
Fig 11
To Next Page
Loading...
