Husqvarna 455 Rancher II - Maintenance schedule

38 – English
Fig 37b
8
Use a small at screwdriver to snap open the con-
nector from the black attachment. Separate the
connector by pressing down the catch with a at
screwdriver and then pulling the unit apart. See
gure 37b.
NOTE!
The lug on the carburetor is securely
attached to the partition wall.
5
Undo screws E. Unhook the rubber mountings D
on both sides. See Figure 36b.
6
Remove the air lter holder.
7
Note! The lug on the carburetor must be detached
from the partition wall before the carburetor can be
removed. See gure 37a.
Fig 37a
Repair Instructions
D
D
D
E
E
Fig 36b