Husqvarna 455 Rancher II - Page 54

54 – English
Fig 75
1
Fit the complete crankshaft in the crankcase.
See gure 75.
Assemble the following parts:
• piston and cylinder *
• handle system
• hand guard
• mufer *
• carburetor*
• throttle pressure rod
• centrifugal clutch *
• starter *
• cylinder cover
• clutch cover
• chain and bar.
* See specic instruction.
Assembling a complete crankshaft
Repair Instructions
3
Fit the new bearing on the crankshaft using tool
502 50 30-18. See gure 73.
Fig 74
NOTE!
Take care to prevent any dirt or foreign
particles from entering the bearings.