English - 22
Search Not connected, GPRS link
OK.
The mower can search for up
to 5 minutes from when the
main switch is turned on.
Blocked Communication board
blocked (blacklisted).
Serial number of hardware
card not registered on
Husqvarna server. Replace
the board.
SIMs Data not transmitted (may
be due to problem with
SIM card).
Automower Connect is
attempting to transmit data
but the Husqvarna server is
not receiving. This can be
caused by the fact that the
money has nished if using a
cash SIM card.
PIN SIM PIN required.
PUK SIM PUK required.
Locked The SIM card is locked.
- Automower Connect not
active / No SIM card.
• RSSI status: Signal strength of GPRS
reception between 0-98, the higher the value,
the better the reception. The value should be
greater than 10 for a stable connection.
• Operator status: The operator to which the
operator is connected, e.g. Telenor.
• GPS signal: Strength of GPS reception.
In order to set the center position of the
Geofence, the GPS signal must be "Strong".
2.1.3 History
The History - Messages - Fault messages display
mode shows the last 50 fault messages that have
been displayed when the mower has stopped.
The By date display mode shows for each message:
• Position in the message list, e.g. 1.
• Message title
• Date and time when the message was set.
2. SPECIAL MENU FUNCTIONS
To Next Page
Loading...
Need help?
General
