3.2
RESTORING MACHINE TO USE
After completion of all repairs or maintenance to the locked-out machine, it shall be restored to use as follows:
The person(s) who performed the work shall verify that all areas around the machine are safe, before the machine is
re-energized. No-one shall be permitted in un-safe areas around the machine. All guards and covers shall be properly
installed.
Each lock-out padlock shall be removed by the person who applied it.
After the lock-out padlocks are removed, and before the machine is started, the supervisor and all other employees who
use the machine, shall be informed that the lock-out has been removed. After notication is made, the machine may be
re-started.
BLADE CHANGE MODE PROCEDURE
Wear safety glasses, gloves, and a long sleeve shirt for protection when handling band saw blades during blade change.
NOTE THAT GLOVES SHOULD NEVER BE WORN NEAR A RUNNING BANDSAW BLADE. When handling new blades,
or ones that will be re-used, it is important to keep the teeth out of contact with concrete oors.
This machine is equipped with hydraulic blade tension and a ‘Blade Change Mode’ key switch, located on the operator
control panel.
This key has two positions:
OFF or O – All normal operations of the band saw are operative.
ON or I – Hydraulic motor can be started.
Blade tension is operative.
Guide Arm is operative.
BLADE CHANGE MODE DECAL: NORTH AMERICA & EUROPEAN VERSION
BLADE TENSION DECAL: NORTH AMERICA & EUROPEAN VERSION
To Next Page
Loading...