General Maintenance
6-32 SlideSmart DC Installation and Reference Manual Revision D
To install the two new batteries, reverse the removal procedure.
1. Connect the red wire to the red terminal on the left battery and
slide the battery onto the tray.
2. Attach the blue wire to the black terminal.
3. Insert the second 8Ah battery and connect the blue wire to the red
terminal).
4. As you slide the battery onto the tray, connect the black wire to the
black terminal on the right battery.
See Figure 6-19.
Figure 6-19.
If you have difficulty removing the batteries through the access hole, an optional method for
battery replacement is to remove the control box. Four Phillips-head screws secure the control
box to the chassis. Remove the screws and remove the control box to access the batteries. Be
careful that you do not inadvertently disconnect the control box wire bundles. An assistant
for this alternative method of battery removal/replacement is highly recommended. See
Figure 6-20.
Figure 6-20.
Red
wire
Blue wires
Black wire
Wire ties
8Ah batteries
Right
battery
Four Phillips-head
screws secure the
control box to the
chassis.
Battery access
window
Control box
Slide cover
off the
control box
to access
the screws.
Cut
8Ah
battery
wire ties
To Next Page
Loading...
Need help?
General
