Hytera X1p Owner's Manual

14

Services on the analog channel: to send calls to
the 5-Tone or 2-Tone contact.

Services on the digital channel:
»
To send group calls or messages to the group
call contact.
»
To send private calls, messages or make
control services to the private call contact.
The control services contain: Alert Call, Radio
Check, Remote Monitor, Radio Enable or
Radio Disable.
Alert Call
You can send an alert call to a private call
contact. The called party will see the alert and
can call you back.
Radio Check
You can send a Radio Check command to a
private call contact, so as to conrm whether
it is powered on or running on the current
channel without disturbing it.
Remote Monitor
You can enable the microphone of a private
call contact, and monitor its activities or
background voice remotely.
Radio Enable
You can enable the radio of a private call
contact remotely and allow it to be used
normally.
Radio Disable
You can disable the radio of a private call
contact remotely and disallow it to be used
normally.
Operation:
Service Operation
To send private calls/group
calls on the digital channel.
Press the One
Touch Call key and
then hold the PTT
key.
To send calls on the analog
channel.
Sending a Message
To make control services
on the digital channel.
Press the One
Touch Call key.
Telemetry
This feature allows you to remotely supervise the
device connected with a radio. With this feature, you
can control the device and view its status in the case
that you are away from the device.
The method for supervising the device is
programmable by your dealer. The available methods
are:

To supervise the device via the radio
If a device is connected with a radio, you can
use another radio to supervise the device. All
the radios involved should be configured with
the Telemetry feature. For example, the dealer
enables the Telemetry feature for both Radio A
and Radio B, and assigns the Telemetry feature
to the SK1 key on Radio A. To supervise the
Device C, connect it with Radio B, and press the
SK1 key on Radio A.

To supervise the device via a third-party software
If the Telemetry feature is enabled for the radio
by your dealer, you can supervise the device
connected with the radio via third-party software.
Priority Interrupt
Manual Priority Interrupt
You can have the priority of interruption by pressing
the programmed Priority Interrupt key. By pressing
this key, you can terminate the ongoing activity (a
call, Call Hold Time or remote monitoring) on the
current channel, so as to initiate a new call or data
service.
Call Hold Time: the duration the radio stays at in-call
status after the end of the call. There are two types:
Group Call Hold Time and Private Call Hold Time.
Within the time, you can hold the PTT key to directly
call back.
Auto Priority Interrupt
The Auto Priority Interrupt is enabled by the dealer.
It is designed to ensure the priority given to the
specified services. Such services will trigger the
interruption automatically.
Emergency Priority Interrupt
This function is designed for users to report an
emergency alarm in time. Carrying this function
would interrupt the active call on the current channel.
To carry out the function, any of the following ways is
available:

Press the programmed Emergency On key.

Hold the PTT key in Emergency mode.

Auto Emergency Call
Call Back Priority Interrupt
With the feature enabled, you can hold the PTT
key to interrupt a receiving call and call back. For
example, user A is receiving a call from user B. This

Hytera X1p Specifications

General

Brand	Hytera
Model	X1p
Category	Portable Radio
Language	English