Hytera X1p Owner's Manual

20
LED
This menu allows you to set whether to turn on LED
indicator. Generally, the LED indicator can indicate
TX/RX, Scan/Roam status, Low Battery, etc. The
indications of the LED are set by the dealer.
Tone
You can select the tones on actual requirements.
Tone Description
Radio
Silent
This feature disables all the tones.
Talk Permit
This option decides whether the tone
will be given during transmission. The
following options are available: Disable
(no tone indication for transmission),
Digital Only (tone indication for
transmission on digital channels
only), Analog Only (tone indication
for transmission on analog channels
only), and Enable (tone indication for
transmission on both analog and digital
channels).
TextMsg
The tone given when the radio receives
a message.
Keypad
The tone given when you are operating
the keypad.
Low
Battery
The tone given when the radio is in low
battery status. Then you will need to
replace the battery.
Call End The tone given upon a call ending.
Group Call
The tone given when the radio receives
a group call.
Private Call
The tone given when the radio receives
a private call.
Voice End
This option decides whether the radio
sounds an alert tone after it stops
receiving.
Tone Description
Channel
Notify
The announcement given when you are
switching the channels via the Channel
Selector knob. The radio announces
the channel number only if the channel
is switched via the Channel Selector
knob or Channel Up/Channel Down/
Preset Channel key.
Signaling
Side Tone
The continuous tone given when the
radio is transmitting the signaling. It is
available for call in HDC1200/5-Tone/2-
Tone system.
Emer
Alarm
The tone given when an emergency
alarm is received.
Priority
Channel
The tone given when the radio
observes the priority channel.
Alert Call
The tone given when an alert call is
received.
Power on
The tone given when the radio is
powered on.
Vibration
This option is to set whether to enable the Vibration
feature. With this feature enabled, the radio can give
vibration indications upon the receipt of a message,
private call or alert call.
Password
To set the power-on password for the radio.
Option Board
When the option board is enabled, it allows a third
party to achieve further development with the radio.
For example, use the radio to send a message to
some other equipment.
Programming
You can modify the frequency, color code and slot
information for the current channel.

Frequency: You can set the TX/RX frequency
within the required range.

Color Code : It is used to identify a system.
Radios to communicate with each other must be
assigned with the same color code.
Value range: an integer between 0 and 15.

Slot : You can select the slot for calls and data
transmission.
Device Info
With this option, you can view basic information of
your radio, including Radio Alias, Serial Number,
Model Name, Frequency Range, Firmware Version,
Radio Data Version, Boot Loader Version, etc.
Go to “Main Menu -> Settings -> Device Info”.
Battery Power Indicator
This feature allows you to know the current battery
strength.
Hold the programmed Battery Power Indicator
key, and the radio will give a specific indication to
represent the current battery strength. Release this
key to exit.
Indication
Battery Power
Icon
Battery
Power
LED glows green. High
LED glows orange. Medium
Red LED glows. Low
LED glows red and
the low battery alert
sounds.
Insufcient

Hytera X1p Specifications

General

Brand	Hytera
Model	X1p
Category	Portable Radio
Language	English