Hytera X1p Owner's Manual

24
contact information (or “Five Tone Call”) and an
appropriate call icon (Private Call: ; Group
Call: ). If Auto Reset is enabled (by your
dealer), your radio will enter the Auto Reset mode
after successful encoding, with the LED glowing
orange, until the Auto Reset Time expires.
Decoding:
Your radio can automatically decode the 5-Tone
signaling when receiving any matched one.
During decoding, the LED glows green. After
successful decoding, the LCD displays the contact
information (or “Five Tone Call”), an appropriate call
icon (Private Call: ; Group Call: ), and the
decoded status message. If Auto Reset is enabled
(by your dealer), your radio will enter the Auto Reset
mode, with the LED glowing orange, until the Auto
Reset Time expires.
2-Tone
With this signaling, the radio can transmit and receive
2-Tone calls.
Encoding:
1. Request your dealer to configure the correct
format and type for the encoding contents.
2. Press the PTT key or the programmed One
Touch Call 1 – One Touch Call 5 keys to send
the 5-Tone signaling.
During encoding, the radio sounds a side tone,
the LED glows red, and the LCD displays the call
icon with contact information above it. If
Auto Reset is enabled (by your dealer), your radio
will enter the Auto Reset mode after successful
encoding, with the LED glowing orange, until the
Auto Reset Time expires.
Decoding:
Your radio can automatically decode the 2-Tone sig-
naling when receiving any matched one.
During decoding, the LED glows green. After suc-
cessful decoding, the LCD displays the call icon
and the call type (selective call, alert call w/voice,
alert call) below the icon according the decoding
type.
If Auto Reset is enabled (by your dealer), your radio
will enter the Auto Reset mode, with the LED glowing
orange, until the Auto Reset Time expires. The radio
cannot enter the Auto Reset mode if it is an alert call.

Hytera X1p Specifications

General

Brand	Hytera
Model	X1p
Category	Portable Radio
Language	English