What to do if my Hytera Two-Way Radio can't be powered on?
If your Hytera Two-Way Radio won't power on, the battery may be improperly installed, so remove it and attach it again. Alternatively, the battery may be drained; in this case, recharge or replace it. Also, check the battery contacts for dirt or damage and clean them. If cleaning doesn't resolve the issue, consider further inspection.
Why is the voice weak on my Hytera Two-Way Radio?
If the voice is weak, discontinuous, or totally inactive when receiving signals on your Hytera Two-Way Radio, the battery strength may be too low, so recharge or replace the battery. Ensure the volume isn't set too low by increasing it. Also, check that the antenna is properly installed; power off the product and then reinstall the antenna. Finally, the speaker may be blocked or damaged; clean the speaker surface, and if that doesn't work, further inspection may be needed.
How to fix communication issues on Hytera Two-Way Radio?
If you cannot communicate with other members using your Hytera Two-Way Radio, it could be due to inconsistent frequency or signaling; set your TX/RX frequency and signaling to match other members. Also, ensure all members are using the same channel type (digital/analog). Finally, you may be too far away from the group; move closer to other members.
What to do if the noise is too loud on Hytera Two-Way Radio?
If the noise is too loud on your Hytera Two-Way Radio, you might be too far from other members; try moving closer. Also, your position could be unfavorable, such as being blocked by buildings or underground; move to an open and flat area and restart the product. External disturbances like electromagnetic interference can also cause this; stay away from equipment that may cause interference.
Why am I hearing noise on my Hytera Two-Way Radio?
If you're hearing irrelevant communication or noise on your Hytera Two-Way Radio channel, it could be due to interference from other products using the same frequency; change the frequency or adjust the squelch level. Alternatively, your product may be set with no signaling; set signaling for all member products to avoid interference at the same frequency.
Why GPS is not working on Hytera Two-Way Radio?
If the GPS on your Hytera Two-Way Radio cannot locate your position, it may be because no GPS signal is being received. Move to an open and flat area, and restart the product.
General| Zone Capacity | 16 |
|---|---|
| Operating Voltage | 7.4 V |
| Keypad | Yes |
| Vocoder Type | AMBE+2 |
| Audio Output Power | 0.5 W |
| Storage Temperature | -40°C to +85°C |
| IP Rating | IP67 |
| Bluetooth | Yes |
| Frequency Range | VHF: 136-174 MHz, UHF: 400-470 MHz |
| Channel Spacing | 12.5/20/25 kHz |
| Battery | Li-Ion 2000 mAh |
| Display | LCD |
| Digital Protocol | DMR |
| RF Power Output | VHF: 5 W, UHF: 4 W |
| Operating Temperature | -30°C to +60°C |
| GPS | Yes |
To Next Page
