4
3. Place where noise generates due to electrostatic, etc.
4. Place where the product may come in contact with radiation
● Do not install the product in a place subject to vibration or shock.
● Provide an emergency stop device in an easily accessible position so the device can be immediately
actuated should danger occur during operation. Failure to do so may result in injury.
● Provide sufficient maintenance space when installing the product. If sufficient space is not available, daily
inspection, maintenance and other necessary work cannot be carried out, resulting in system shutdown or
product damage.
● When transporting or installing the product, support the product using a lift or suspension equipment or
carry it with multiple operators working together, and exercise due caution to ensure safety.
● When installing the product, do not hold the moving parts or cables of the product. Doing so may result in
injury.
● Use IAI’s genuine cables to connect the actuator and controller. Also use IAI’s genuine components for
the actuator, controller, teaching pendant, etc.
● The brake mechanism is designed to prevent the slider from dropping upon turning off the power when the
actuator is installed vertically. Do not use the brake mechanism as a safety brake.
● When installing, adjusting or carrying out any other work on the actuator, put up a sign bearing “WORK IN
PROGRESS. DO NOT TURN ON POWER” or other warning statement to that effect, to prevent the
product from being powered on accidentally. If the power is turned on accidentally, injury may result due to
electric shock or sudden movement of the actuator.
● Turn on the power to individual equipment one by one, starting from the equipment at the highest level in
the system hierarchy. Failure to do so may cause the product to start suddenly, resulting in injury or
product damage.
● Do not insert a finger or object in the openings in the product. It may cause fire, electric shock or injury.
● Do not step on the product, use it as a footstool or place any object on it. It may cause scoring, dents or
deformation of the driving part, resulting in product damage, unintended stopping due to damage, or
performance drop.
● Wear protective goggles when applying grease to the actuator. Failure to do so may result in eye
inflammation due to spattered grease.
● If the product is used in a vertical setup, make sure to use the vertical specification (with brake).
● Protection covers or other guards must be provided for the moving parts of the equipment to avoid direct
contact with the operators.
● Do not configure a control circuit that will cause the work to drop in case of power failure. Configure a
control circuit that will prevent the tabl
e or work from dropping when the power to the machine is cut off or
an emergency stop is actuated.
Maintenance, Inspection, Repair
Operation
Note
Installation
To Next Page
Loading...
