● The following conditions must be met in order to improve the straightness of the table movement and
ensure the smooth movement of the ball screw and linear guides:
1. Flatness of the mounting surface must be within 0.05mm.
2. The mounting surface area must be large enough to ensure the rigidity of the actuator.
● When handling the product, wear protective gloves, protective goggles, safety shoes or other necessary
gear to ensure safety.
● When performing maintenance, apply the specified grease to the guides and ball screw. Pay special
attention not to let fluoride grease mix with lithium grease. The machine may be damaged due to poor
lubrication, increased resistance, etc.
● When the product becomes no longer usable or necessary, dispose of it properly as an industrial waste.
■ IAI shall not be liable whatsoever for any loss or damage arising from a failure to observe the items
specified in “Safety Precautions.”
Installation, Operation, Maintenance
Maintenance, Inspection, Repair
Disposal
Others
To Next Page
Loading...
