IBM Flex System p260 - Page 212

BA01B013
Explanation: The discover mode is invalid
Response:
1. Reboot the server.
2. If the problem persists: Search RETAIN tips and the firmware change history for the reference code to determine
the recommended actions. If a firmware update is needed, see Updating the firmware
BA01B014
Explanation: Closing the BOOTP node failed
Response:
1. Reboot the server.
2. If the problem persists: Search RETAIN tips and the firmware change history for the reference code to determine
the recommended actions. If a firmware update is needed, see Updating the firmware
BA01B015
Explanation: The BOOTP discover server timed out
Response: Perform the following actions that checkpoint CA00E174 describes:
1. Verify that:
v The bootp server is correctly configured; then retry the operation.
v The network connections are correct; then retry the operation.
2. If the problem persists: Search RETAIN tips and the firmware change history for the reference code to determine
the recommended actions. If a firmware update is needed, see Updating the firmware
BA01D001
Explanation: Opening the DHCP node failed
Response:
1. Reboot the server.
2. If the problem persists: Search RETAIN tips and the firmware change history for the reference code to determine
the recommended actions. If a firmware update is needed, see Updating the firmware
BA01D020
Explanation: DHCP failed to read from the network
Response:
1. Verify that the network cable is connected, and that the network is active.
2. If the problem persists: Search RETAIN tips and the firmware change history for the reference code to determine
the recommended actions. If a firmware update is needed, see Updating the firmware
BA01B013 • BA01D020
200 Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide